Much Ado About Ejector Rod Length

If you hang around RevolverGuys long enough, you will eventually run across a discussion of ejector rod length. It seems that often this will take the form of, “so-and-so revolver doesn’t have a long ejector rod” or “I’ll by X instead of Y because it has a full-length ejector rod.” Frequently this conversation seems to be based around superficial factors, and I’m guilty of this myself. Continue reading “Much Ado About Ejector Rod Length”

The Kimber K6s DC: Notes From The Field

The Kimber K6s revolver was introduced at the 2016 SHOT Show, and while I got to handle it in the Kimber booth, I didn’t get to shoot it until the following year’s Media Day at the Range. That first cylinder full convinced me that I was holding a very special gun, and would need to spend more time with it in the future. Continue reading “The Kimber K6s DC: Notes From The Field”

The Biggest Little Roundgun: The 3-Inch Kimber K6s

It is no secret to regular readers that I have been dying to get my hands on the 3-inch Kimber K6s. Thanks once again to the hard work of Mike and Steve, I finally got my chance to test out this revolver. This field report will cover my general impressions, and shooting and carrying what I have dubbed the “biggest little roundgun!” Continue reading “The Biggest Little Roundgun: The 3-Inch Kimber K6s”

The Kimber K6s: From a Blank Sheet of Paper

I admit it. I’m a gun nut. It doesn’t matter if they revolve or cycle, or if they load from the front, the back, or the bottom. It doesn’t matter if they hold a single cartridge or half a box full. It doesn’t matter if they’re made of blue steel and wood, or Tenifered steel and plastic. If they go “bang,” I love them.

Continue reading “The Kimber K6s: From a Blank Sheet of Paper”